XL Fighter BL - 1:10XL 3S brushless RTR
Anleitung/ Manual (PDF Download)
The proven DF Models BasicLine models are now also available in an XL variant!
Front and rear axle unit are identical to the BasicLine Truck models. The chassis was used from a 1:8 model ... This results in the BasicLine XL model.
The XL Fighter BL comes RTR (Ready To Run) and is equipped with a 3S (11,1 Volt) LiPo drive battery and a LiPo balancer charger. The XL Fighter BL is powered by a 3S LiPo battery in conjunction with a 2000kv motor and 60A brushless controller (Hobbywing WP-10BL60A), allowing top speeds of approximately 70 km/h!
An aluminum motor heat sink with fan provides sufficient cooling for the motor to avoid overheating.
There are already many tuning parts installed from the factory ... A center differential distributes the power of the engine evenly between the front and rear axles. This results in a soft start-up where the power is transferred in a targeted manner. It also protects the model's drive components. Aluminum chassis, aluminum upper deck, aluminum wishbone mounts, oil pressure shock absorbers with aluminum parts, servo with metal gears, CVD shafts front and rear, etc.
A special feature is the new 4-channel remote control. The maximum speed can be reduced by 50% via transmitter. Thus, the models are ideally suited even for novice drivers! The system also has 2 additional switching channels, which can be used, for example, to switch a special function (additional modules may be required).
Scope of delivery:
RC Truggy RTR
2,4 GHz remote control
LiPo drive battery - 11,1 Volt - 3300 mAh
LiPo balancer charger
Drive: 4WD brushless (2000kv)
Length: 485 mm
Width: 340 mm
Height: 190 mm
Wheelbase: 325 mm
Speed: up to 70 km/h
Tires: 120x70 mm